how do you connect a turn on lead to a car amplifier?

im not sure how to do it.. at all. i just bought an amplifier wiring kit and it comes with a thin blue wire. i know it connects to the turn on wire thats in the back of my aftermarket stereo its just i dont know how to connect them.

Your going to have to remove your stereo from the dash to install the amp wiring kit. This will give you access to the RCA output jacks and let you connect the remote turn on wire also. It is usually a blue wire on the back of your stereo and may also be marked with a sticker or tag identifying it. Check out this guide for installing an amp. Good luck.

http://www.car-stereo-setup.com/car-amplifier-installation.html

This entry was posted on Sunday, February 21st, 2010 at 5:10 am and is filed under car amplifier. You can follow any responses to this entry through the RSS 2.0 feed. You can leave a response, or trackback from your own site.

One Response to “how do you connect a turn on lead to a car amplifier?”

Zink on February 21st, 2010 at 10:38 am

Your going to have to remove your stereo from the dash to install the amp wiring kit. This will give you access to the RCA output jacks and let you connect the remote turn on wire also. It is usually a blue wire on the back of your stereo and may also be marked with a sticker or tag identifying it. Check out this guide for installing an amp. Good luck.

http://www.car-stereo-setup.com/car-amplifier-installation.html
References :

Acoupower